utilize adhesives in many areas of construction. As you know,
not only body side moldings and decals, but even stationary glass and some
body panels are held in place with special urethane and epoxy adhesives.
Many times, body shop operations require R&I of these parts. The
Inductor2000™ family of flameless heating tools gives the
technician the ability to save valuable time when it is necessary to R&I
any part bonded to a metal structure, and in most cases lets you save the
How Does it Work ?
The Inductor™ utilizes a high
frequency electromagnet field that heats only
metal objects (or objects containing metal) when they come into close
The magnetic field goes right through non-metals like glass and trim and
heats the metal underneath.
What can I use it for?
Basically anything that is bonded to metal with adhesives can be easily
removed by heating the metal with this magnetic field. This in turn softens
the adhesive and releases its bond.
Unlike using any flame tool, The Inductor™ also lets
you heat metal in tight areas without the extreme need to remove plastic
shields that may be in close proximity of the area being heated. Instantly
pre-heat cold metal to install adhesive stripes, moldings, etc... no need to
wait! The uses are endless!
- Body Side Moldings
- Weather Stripping
- Glass (Including Module Glass)
- Rubber Strips
- Pin Stripes
- Seam Sealers and Caulking
- Hail Dents
- Bonded Panels from Metal
- Spray-On Bedliners and Sound Deadening Pads
- Pre-heat cold panels quickly for parts installation
- Shrink metal
there is no faster way
to remove parts bonded by adhesives
to use ... just rub the pad along the part where adhesive
parts can be removed and the part
even within inches computers and electronics are not
Improves Quality -
interior trim may no longer require removal for
stationary glass removal
New technology -
never before has this technology been used
in this industry
This tool carries a 30 day full money back